How to remove old anti-fouling from your vessel

To remove the anti-fouling, you need to get your vessel out of the water. Depending on its size, you can do this yourself or use a commercial slipway or dry dock.

Most small craft owners would first consider scraping and sanding the surface themselves. This method works well, but can be very exhausting. There is also the problem that the paint dust is actively toxic. You don't want to breathe it and you don't want to get it into the environment.

Chemical paint removers can save you some elbow grease, but they too involve a health hazard.

Abrasive blasting/sandblasting is both quick and effective, though that requires special equipment and expert operators. It's worth contacting commercial abrasive blasters near marine areas to find out what it would cost for them to remove the anti-foul. It will certainly save you time and trouble, and may cost less than you expect.

If you do decide to use a third-party contractor to remove the anti-foul, you may still want to organise it so you can personally inspect the hull, keel and any other underwater parts once it's been cleaned. You may spot blisters, cracks or other issues that need attention before it's all covered in a protective coating again.

When it comes to recoating your vessel, the universal rule of painting applies – surface preparation is crucial. The surface must be thoroughly clean and dry to allow the new anti-fouling paint to form the best possible bond. Not only the performance of your vessel, but potentially your life could depend on it.

For a gentler clean on your equipment try our Sodablasting Service Sodablasting is safe, environmentally friendly and
  • Cleans steel, metal, fibreglass and concrete surfaces
  • Strips paint from vehicles, boat hulls & masonry
  • Effective and non toxic on food processing equipment
  • Tough on graffiti & contaminates in the industrial sector
  • Is a non destructive cleaning and stripping process


"Tauranga Sandblasting's team constantly delivers high quality work carried out Safely and on time for the last ten years."

Aubrey Gerber - Gull New Zealand Limited

"For the last 3 years we have used Tauranga Sandblasting to blast and re-paint onsite structural steel, refrigeration pipe work and ancillary equipment. Where it is possible, any equipment is relocated to their enclosed and environmentally protected processing facility.

Tauranga Sandblasting have always carried out any work in a professional manner, with due concerns for any environmental, operational and compliance issues before they arise.In conjunction with a paint supplier's specification, we have utilised their experience in recommending  and applying paint systems for long term applications in our harsh environment.

To date, all work done is performing to specification which reflects Tauranga Sandblasting's attention to suitability, preparation and application of paint systems."

Peter B. Martin - Sandford Limited, Tauranga